Communications By Network No./Station No.; Enable/Disable Online Change - Mitsubishi Electric MELSEC iQ-RJ71EN71 User Manual

IP Address
■IP Address
When the parameters are written without setting the IP address, the following address is set.
Module
RJ71EN71
RnENCPU (network part)
CPU module (built-in Ethernet port part)

Communications by Network No./Station No.

■Setting Method
When "Use IP Address" is selected, network number and station number will be set from the third and fourth octet of the IP
address.
For example, when IP address is set to 192.168.1.10, the network number is set to "1" and the station number is set to "10".
When the IP address is used, the value out of the range of the network number and station number cannot be set in the third
octet and fourth octet
When "Not Use IP Address" is selected, set the network number and station number.
When "Port 1 Network Type" and "Port 2 Network Type" are set to "Ethernet" for the RJ71EN71 and the same
network number is set for both of P1 and P2, P1 is always used for relay to other networks.

Enable/Disable Online Change

Select whether to enable SLMP data write command received by the Ethernet-equipped module received while the CPU
module is in RUN state.
This setting is effective for not only the CPU module on the own station but also the ones on the other stations.
When "Disable All (SLMP)" is selected, data writing using SLMP is disabled while the CPU module is in RUN state.
When "Enable All (SLMP)" is selected, data writing using SLMP is enabled even when the CPU module is in RUN state.
To write data to the FTP server when the CPU module is in RUN state, set "Allow Online Change" under "FTP Server
Settings" in "Application Settings". ( Page 252 FTP Server Settings)
P1 connector
P2 connector
P1 connector
IP address
192.168.3.40
192.168.4.40
192.168.3.40
192.168.3.39
2 PARAMETER SETTINGS
2.2 Basic Settings
2
243