Installing Partitions; Installing End Assemblies - Hussmann Freedom Line series Installation & Operation Manual

I
1-16
nstallatIon

INSTALLING PARTITIONS

To join same temperature fixtures on different
defrost cycles, an acrylic partition kit is
required.
To join like or unlike fixtures operating at
different temperatures, a 11/2 in. (38 mm) parti-
tion kit is required. It must be installed when
setting the lineup.
Instructions for installing these partitions are
included with the kits.

INSTALLING END ASSEMBLIES

The following information is provided for field
or retrofit installation:
1. Prepare Merchandiser
a. Remove shelves (if installed), display
racks, pans, front shelf supports and front
air grilles from the section of merchandiser
where end is to be installed.
b. Remove the interior rear panel(s). On
multi-deck merchandisers, remove the
lower back panel, lift it up from its
bottom edge and out. No tools required.
c. Right End Only
Install Nut Retainers into right end frame
at locations shown.
d. Left End Only
Check that factory-installed Nut Retainers
are in place.
e. Remove bumper by pulling bumper
away from bumper retainers. Be careful
not to lose the internal joint trims.
P/N 0527427_M
f. Optional Front Rail Light Only
Check that end cap is in place before
gaskets are applied.
2. Apply Gaskets to End Frame as Follows:
a. Apply the 15/8 in. (41 mm) gasket to
canopy and rear of the merchandiser as
shown on the next page. It must be at the
edge. Check to be sure that there are no
gaps between merchandiser and gasket.
b. Apply the 1 inch (25 mm) gasket from
front to back. It should lap the 15/8 in.
gasket at the rear. Check to be sure that
there are no gaps between merchandiser
and gaskets. Refer to detail below.
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
Gasket
5
1 / in. (41 mm)
8