Hussmann Freedom Line series Installation & Operation Manual page 57

P/N 0527427_M
d noT
o operaTe refrigeraTion sysTem
T i
ouTside ype and
o c
peraTing ondiTions
p
oor performance of refrigeraTion
sysTem may resulT from conTinuous
operaTion ouTside of The following
:
condiTions
ANSI/NSF-7 Type I – Display Refrigerator / Freezer
Intended for 75°F / 55%RH Ambient Application
ANSI/NSF-7 Type II – Display Refrigerator / Freezer
Intended for 80°F / 55%RH Ambient Application
e
vaporator pans may overflow
flooding during conTinuous operaTion
in exTreme sTore TemperaTures
After system startup and after 24 hours of
operation make sure to verify that the oil level
in the compressor is at
compressor. Add compressor manufacturer's
recommended type oil as needed to maintain
correct level.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
START-UP / OPERATION
T ii a
ype mbienT
.
,
causing
.
1
/ site glass on the
2
If refrigeration system operation is required
for functional verification, please follow the
recommendations below:
» Install display case shelves before operation.
» Drafts from open doors, fans, or other
sources must be avoided.
» Air discharge and return flues must
remain open and free of obstruction at
all times.
» Temporarily set the refrigeration control
knob to the warmest position for operation
during non-controlled ambient conditions,
to keep defrost water build-up to a minimum.
» If heater pans have been de-energized
following a defrost cycle, standing water
will remain in the pans. Re-energize
power to the pans long enough to remove
remaining water before restarting
refrigeration during non-controlled
ambient conditions.
Do not walk on top of case.
Do not store items or flammable
materials atop the case.
Tipping Hazard
Case tipping may occur if cases are not properly
leveled and secured, or if cases are not properly
loaded.
Freedom Line Multi-Deck
4-1