P/N 0463880_E
INSTALLING PARTITIONS
To join same temperature fixtures on different
defrost cycles, an acrylic partition kit is
required.
To join unlike fixtures, or like fixtures operating
at different temperatures, a 1
tition kit is required. It must be installed when
setting the lineup.
Instructions for installing these partitions are
included with the kits.
INSTALLING END ASSEMBLIES
The following information is provided for field
or retrofit installation.
1. Prepare Case
a. Remove shelves (if installed), display
racks, pans, front shelf supports and front air
grilles from the section of case where end is
to be installed.
b. Remove the interior rear panel(s). On
multi-deck cases remove the lower back
panel first. To remove a panel, lift it up from
its bottom edge and out. No tools required.
c. Right End Only
Install Nut Retainers into right end frame at
locations shown.
d. Left End Only
Check that factory-installed Nut Retainers
are in place.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
1
/
in. (38 mm) par-
2
e. Remove bumper by pulling bumper away
from bumper retainers. Be careful not to lose
the internal joint trims.
f. Optional Front Rail Light Only
Check that end cap is in place before gaskets
are applied. See Page 1-19 for details.
2. Apply Gaskets to End Frame as Follows:
5
/
a. Apply the 1
8
canopy and rear of the case as shown on
Page 1-14. It must be at the edge. Check to
be sure that there are no gaps between
merchandiser and gasket.
b. Apply the 1 inch (25 mm) gasket from
front to back. It should lap the 1
at the rear. Check to be sure that there are no
gaps between case and gaskets. Refer to
details below.
Gasket
1
5
/
8
Detail for
Glass
Front
End Gasket
Medium Temperature
in. (41 mm) gasket to
5
/
in. gasket
8
in. (41 mm)
Gasket
1
in. (24 mm)
Excel
1-13