Hussmann Freedom Line series Installation & Operation Manual page 21

P/N 0527427_M
b. Install full-length bumpers and internal
trims offset across joints. Make sure that
no gaps exist between sections. Continue
installing the bumpers the length of the
lineup.
5. Once all except the last section of bumper
have been installed, refrigerate the merchan-
diser lineup for at least six (6) hours. The
last section of bumper should be kept inside a
cooler or refrigerated merchandiser during this
time. This will allow the bumper to contract.
6. Go to the right end of the lineup, and tap
the bumper to close any gaps.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Starter
Bumper
Retainer
Internal Joint Trims
Merchandiser
Joint
Full Length
Bumper
7. Measure and cut last
sections of bumper. Use a
miter box and fine-tooth
saw to cut last bumper to
length. Install the last
section.
8. Remove protective
film from bumper once installation is complete.
Freedom Line Multi-Deck
1-15
Bumper
Miter Box