Table of Contents
Advertisement
1-6
I
NSTALLATION
6. Continue installing the top rails the length of
the line up. Do NOT install last section at this
time.
7. Once all except the last sections of the bumper
and top rail have been installed refrigerate the
case line up for at least six (6) hours. The last
sections of bumper and top rail should be
kept inside a refrigerated case or cooler
during this time. This will allow the bumpers
and top rails to contract.
8. Go to the right end of the line up and tap the
top rail and bumpers to close any gaps.
9. Measure and cut last sections of top rail and
bumpers. Use a miter box and fine-tooth saw
to cut last bumpers and top rail to length.
Install the last sections.
Miter Box
P/N 428668A
Bumper
Note: If part of plastic top rail pops loose, remove
that section of top rail and re-install according to
Step 5. Trying to re-install only the popped part
may not secure the top rail, and may damage the
top rail, color panel and light channel.
10. Slide alignment strips between front glass
sections at each joint.
CW2 End Case Only
Install the base plate as shown below when joining
a CW2 end case to the lineup.
Joint Base Plate
INSTALLING PARTITIONS
To join same temperature fixtures on different
defrost cycles, an acrylic partition kit is required.
To join unlike fixtures, or like fixtures operating
at different temperatures, a 1
tion kit is required. Instructions for installing the
partitions are included with the kit.
End Case
1
/
in. (38 mm) parti-
2
Advertisement
Table of Contents
