Install Shelves; Multi-Deck Shelf Configuration; Shelf Maximum Weight Limits - Hussmann Freedom Line series Installation & Operation Manual

P/N 0527427_M

INSTALL SHELVES

Begin with the lowest row of shelves. Verify
the shelf brackets are at 90 degrees to shelf.
Keep shelf level from side to side while tilting
the front down to insert the lowest tab in the
shelf upright. Use a level on each shelf, or
count slots in each upright and mark with tape
to ensure rows of shelves stay level. Tabs must
be seated firmly into position in the uprights
before loading shelves.
Right
Wrong
Even
Vertical
Spacing
in
Upright
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Remove
Shipping
Clips
Uneven
Vertical
Spacing
in
Upright

MULTI-DECK SHELF CONFIGURATION

The bottom display shelves can be adjusted
to accommodate shallow or volume displays
(bulky items such as hams or chickens). The
upper shelves are individually mounted in 1 in.
(25 mm) increments and have two-, three-, or
four-position brackets permitting shelves to be
placed in a flat or down-tilt position (see illus-
tration). Front product stops are recommended
when shelves are placed in the down-tilt position.
Merchandiser performance will be degrad-
ed if peg shelves are used without baffles.
Unauthorized specialty shelving may cause poor
merchandiser performance also. Consult your
Hussmann representative to ensure optimum
performance of all Hussmann equipment.
2-Position 3-Position

SHELF MAXIMUM WEIGHT LIMITS

Hussmann merchandiser shelves are designed
to support the maximum weight load limits as
indicated in the table below.
Freedom Line Multi-Deck
4-3
4-Position