Exterior Loading; Merchandisers Shipped With End Installed; Moving Merchandisers Into Position; Shipping Braces - Hussmann Freedom Line series Installation & Operation Manual

P/N 0527427_M

EXTERIOR LOADING

Do NOT walk on top of merchandisers or
damage to the merchandisers and serious
personal injury could occur. T
sTrucTurally designed To supporT exces
sive exTernal loading
a person. Do not place heavy objects on the
merchandiser.
MERCHANDISERS SHIPPED
WITH END INSTALLED
If the merchandiser was shipped with the end
installed, two long bolts were used to hold the
shipping brace to the end. If the shipping bolts
are reinserted after removing the brace, they
will extend into the product area. T
be sure To replace These bolTs wiTh The
shorTer bolTs provided
bolt or screw in the product area be capped
or cut off if it has more than three exposed
threads.
NOTE:
Be careful not to damage the factory
installed end while moving the case. Make
sure that tools are positioned past the end
and beneath the merchandiser's support bar.
MOVING MERCHANDISER INTO
POSITION
The electrical box and GFCI receptacle are
mounted on top of the case. They can be tem-
porarily detached and suspended if required
to provide clearance for door openings during
shipment and installation. Do not suspend these
components by their wire conduits. The case
height without these components installed on
top is 81.75 in. (2102 mm). Be sure to replace
all screws and to secure all components. The
condensing unit produces vibration that can
cause screws to loosen. See photo at upper left
corner of this page.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
hey are noT
-
such as the weight of
,
herefore
. NSF requires any
Secure Flex Hoses When Detached

SHIPPING BRACES

Move the merchandiser as close as possible
to its permanent location and then remove all
packaging. Check for damage before discard-
ing packaging. Remove all separately packed
accessories such as kits and shelves. Remove
end braces and discard hardware

SHIPPING RIDER

Each merchandiser is shipped on a rider to
protect the factory installed front legs, and
to make positioning the merchandiser easier.
DO NOT remove the front rider until the mer-
chandiser has been positioned. Once the rider
is removed, the case must be lifted –NOT
PUSHED– to reposition. To remove the rider,
remove bolts attaching rider to each leg.
Remove Bolts from Front
Freedom Line Multi-Deck
1-3