IBM 01 Maintenance Manual page 434

ATTACHMENTS
MODELS A6 and 86
o
D.fI.ctot
Figure 7. Front Paper Scale Adjustment
without exerting pressure on them. Difficulty may arise
in rolling back if there is pressure from the feed rolls on
the form. The release lever should always be in the re-
leased position for the normal operation of the pin feed
mechanism. The spring under the actuating shaft arm and
rear feed rolls may be removed if the feed roll release
lever will not remain in a released position.
THE FORMS CARRIER SUPPORT
should be adjusted by
shifting its side frame brackets on the elongated holes so
that the carrier support will be absolutely level.
A.LL
·OTHER
A.DJUSTMENTS are the same as for the
standard lift platen, which is covered in the Forms carrier
section of the Reference Manual.
8