IBM 01 Maintenance Manual page 283

REFERENCE MANUAL
MODELS'" and 5
..
(~
1 Unit or less Clearance
FitJure 16. Unlatched Intermediate GroupintJ Lever
enlarged hole and move it to the right or left to obtain one
unit, or slightly less, clearance between the latch and the
intermediate pawl grouping lever (Figure 16). Note that
the movement of the latch in the direction of the inter-
mediate pawl grouping lever will increase the clearance.
GROUPING LATCH AD'JUSTMENT, TWO-PIECE LATCH.
Position the latch stud to the rear of its enlarged hole.
With the carriage resting on the 1 or 5 pawl, loosen the
screw in the adjustable grouping latch (Figure 17). Posi-
tion the latch for one unit or less clearance (Figure 16)
between the intermediate pawl grouping lever and the
latch.
THE INTERMEDIATE PAWL GROUPING LEVER
is posi-
tioned by rotating the stud, which carries an eccentric
collar located in the pawl aligning lever (Figure 17). Latch
out the tabular lever. Turn this stud to obtain .001" to
.004" clearance between the grouping latch and the short
Intermediate
Pawl Release Lever
FitJure 17. Adjustable GroupintJ Latch
15