IBM 01 Maintenance Manual page 366

REFERENCE MANUAL MODEL A15
F==------{I2
Rebound Engaging Arm
.005" - .015"
____ J
'abound Check Pawl
' J 1X-r
1
Rebound Rack
Ffl1ure 6. Rebound Adjustment
justed at this time. The tab rack should be tilted back
to match the angle of the interposers when latched out.
12.
THE REBOUND ENGAGING ARM on the right end
of the interposer guide assembly is to be adjusted by
mean~
of its elongated holes so that, with the margin lever held
to the extreme left, the rebound check pawl will clear
the rack by .005" to .015" (Figure 6).
13. THE TAB REBOUND CHECK PAWL ECCENTRIC
STUD should be adjusted so that when a set tab stop is
pressed against a latched out interposer, moving the inter-
poser guide assembly to the left, there will be .005" clear-
ance between the face of the check pawl and the face of
the rebound rack tooth. The high point of the eccentric
must be kept in the rear half of its orbit (Figure 7).
14. THE FORWARD EXTENSION OF THE REBOUND
CHECK PAWL should clear the rebound engaging arm by
Rebound Engaging Arm
I=~--@
Rebound Check Pawl
Figure 7. Rebound Clearance
7