IBM 01 Maintenance Manual page 204

REFERENCE MANUAL MOD EL 81
Slight Clearance
Figure 65. Type Bar Centered in Type Guide
right or to the left until it enters the center of the guide.
To do this forming, the three-prong pliers should be used
as illustrated in Figure 66. Centering of the type bar should
be rechecked after every alignment operation.
2. After the type bar is centered in the guide, check the
Application of
3-prong Pliers
Figure 66. Three-Prong Pliers on Type Bar
ring and cylinder adjustment. Insert a sheet of bond paper
in the typewriter and place a test strip of paper, about
1/2" wide and 4" long, between the type bar and ring.
The paper should be gripped tightly between the type bar
65