IBM 01 Maintenance Manual page 249

MOD El .C 1 CUSTOMER ENGINEERING
Figure 35.
Carbon Ribbon Take Up
Installing the Ribbon
To install a ribbon on the new carbon-ribbon
mechanism:
1.
Push the ribbon-release button to the rear, open-
ing the pressure rollers and unlatching the take-up
spool.
2. Slide the take-up spool up and out of its mount-
ing bracket.
3. Separate the two halves of the ribbon spool and
discard the used ribbon.
4. Replace the re-assembled ribbon take-up spool
and latch the mounting bracket.
1
5. Place a full spool of ribbon on the right mount-
ing plate with the inked side of the ribbon toward
you as it comes off of the spool.
6. Thread the ribbon through the right corner- (
guide, center lift-guide, left corner-guide, pressure
guide and onto the take-up spool.
7. Push the ribbon-release button up, re-engaging
the pressure rollers.
38