IBM 01 Maintenance Manual page 259

MODEL Cl
CUSTOMER ENGINEERING
adjust the left gear for maximum engagement with-
out binding. Care must be taken to insure that only (
one of set gears is engaged at a given time.
Pigurs
46.
Trans!w Whssl
Adjfmmsnl
19. TRANSFER WHEEL. With the rewind lever
latched down adjust the transfer wheel, by position-
ing its mounting, so it clears the d!'ive wheel by ~
..
(Figure 46).
20. TRANSFER WHEEL BELLCRANK. With the
rewind lever latched position the bellcrank-eccentric
mounting-stud so that the transfer wheel clears the
flange on the power roll pulley by
*2"
(Figure 46).
NOTE: Adjustments 19 and 20 should be considered
together to insure that the transfer wheel contacts
the drive-shaft wheel and the flange on the power-
roll pulley when the rewind lever is
n"
from its
latched position.
Ribbon Lift Adjustments
Refer to Model Bl, Ribbon Lift, Adjustments 1
I
through 5. (
48
\.