IBM 01 Maintenance Manual page 264

CEM 550, page 4
010-.015
Figure 7
Upper Extension of Cone Follower. With the rewind button
latched and the cone follower held in contact with the smallest
diameter of the cone, form the upper extension so there is
.001" to .005" clearance between the button extension and
cone follower extension (Figure 8).
001 - 005
--rt1
1- -
BunON
l'{TCH~ED
=:-l)
CONE \
r
FORM TAB TO STOP REWIND WHEN
SECONDARY CAM IS 7/8 TO FULL
- . . . \1
TRAVEL UP INCllNE OF PRIMARY CAM-
~.
J
BUTTON DEPRESSED
, I
d
MUST BE SOME CLEARANCE DURING
REWIND
(
( J
(
\
Figure 8 (
Side Extension of Cone Follower. Form the side extension of
the cone follower so when the rewind button is held depressed
at the end of a rewind cycle, the secondary cam will travel
7/8 to full travel up the incline of the primary cam. During
rewind there should be clearance between the side extension
and tip of the transfer wheel bracket (Figure 8). Note: Flick- (
ing the rewind button may cause the RH secondary cam to over-
ride the primary cam occasionally.
Tra,sfer Wheel Mounting Bracket. Form the lower stop so the
transfer wheel clears the power roll pulley flange by .005" to
.015" when at rest (Figure 9). There must be a clearance be- ( \
tween the transfer wheel and the drive wheel.