Community (Com) Group Call - Siemens 300 Series User Manual

Community (Com) Group Call

To call someone
in a com group to
which you have
access
3–18 ROLMphone 300/600 User Guide
Note
If you are talking on the telephone, you can press the
Buzz key without interrupting your call.
Buzz overrides Do Not Disturb mode. (See "Do Not
Disturb" on page 6–3.)
Community (com) groups can be set up at the CBX so
that the members of a group can call each other by
dialing a short com code instead of an extension. A
call from a com group is signalled by a long ring.
On CBX Release 9006.1, you can only be a member
of one group at a time.
On CBX Release 9006.2 and higher, you can be a
member of more than one group at a time and can be
listed in a group more than once. You can also be as-
signed access to groups of which you are not a mem-
ber.
To call a member of your com group, you dial the com
group access code followed by the com code for that
member. If your telephone is a member of a com
group, your CBX system administrator can tell you
the com group access code.
Com groups are set up at the CBX. Groups of up to ten
members have one-digit codes. Groups of more than
ten members have two-digit codes. Ask your CBX
system administrator for a list of the com group mem-
bers to whom you have access.
Get a dial tone.
Dial the com group access code.
Dial the member's com code.