Siemens 300 Series User Manual page 89

To clear a
repdial key on a
display
telephone
If you want to set up another R- key, press the
STORE key. If you have a display telephone,
STORED is displayed. Repeat the two previous
steps.
To end setup, press the PROGRAM key. The
PROGRAM status light turns off. If you have a
display telephone, STORED is displayed.
On your faceplate, use a pencil to label each
R- key you changed with the name of the
feature or person it dials.
Press the PROGRAM key. The PROGRAM
status light turns on. PRESS FEATURE KEY
OR DIAL CODE is displayed.
Press the repdial (R-) key you want to clear.
REPDIAL is displayed, followed by the dialing
sequence.
Before NEW NUMBER? is displayed, press the
CLEAR key. DELETED is then displayed.
To clear another R- key, press the STORE key.
STORED is displayed. Repeat the two previous
steps.
To end setup, press the PROGRAM key. The
PROGRAM status light turns off.
On your faceplate, erase the label next to each
R- key you have cleared.
Note
You cannot clear a repdial key on a non-display
telephone or any telephone without a Clear key,
though you can set it up to dial a different sequence.
Making Calls 3–25