Siemens 300 Series User Manual page 78

To clear a DSS
key on a display
telephone
To dial a DSS
extension
3–14 ROLMphone 300/600 User Guide
Press the PROGRAM key. The PROGRAM
status light turns on, and PRESS FEATURE
KEY OR DIAL CODE is displayed.
Press the DSS (D-) key you want to clear.
DIRECT STATION SELECT is displayed,
followed by the stored extension.
Before NEW NUMBER? is displayed, press the
CLEAR key. DELETED is displayed.
If you want to clear another D-key, repeat the
previous two steps.
To end setup, press the PROGRAM key. The
PROGRAM status light turns off.
On your faceplate, erase the label next to each
D- key you have cleared.
Note
You cannot clear a DSS key on a non-display
telephone or any telephone without a Clear key,
though you can set it up to dial a different extension.
Press the DSS (D-) key for that extension. The
other party will hear a triple beep.
If you press a DSS key while you are on a call,
the CBX will place the first party on
consultation hold before dialing the DSS
extension. To reconnect to the first party, press
the CONNECT key. (See "Consultation" on
page 3–11.)
Note
A DSS call overrides Forwarding and both Station
and Pilot Hunting. (See "Forwarding" on page 5–3
and "Hunt Groups" on page 7–7.)