Automatic Privacy - Siemens 300 Series User Manual

To set up a
repdial key
3–24 ROLMphone 300/600 User Guide
Note
CBX Releases 9006.2 and higher require you to press
the Transfer key (which operates like Flash in
previous releases) as the first element to of some
repdial feature access codes when you are setting
them up. This is necessary with features where you
start out with a call on your line, such as Automatic
Privacy (to turn it off), Bad Line Reporting, Park, and
Privacy. It alerts the CBX that a command is to be
issued from the key pad. Earlier releases do not
require this use of Transfer with repdials.
If unsure of what to do, set up your repdial without
Transfer, and if that doesn't work, redo it with
Transfer. For a list of feature access codes, see
Appendix A, "Feature Access Codes."
If you press a repdial key while you are on a call, CBX
Releases 9006.0 and 9006.1 will place the first party
on consultation hold before dialing. To return to the
first party, press the CONNECT key.
Press the PROGRAM key. The PROGRAM
status light turns on. If you have a display tele-
phone, PRESS FEATURE KEY OR DIAL
CODE is displayed.
Press the repdial (R-) key you want to set up. If
you have a display telephone, REPDIAL is dis-
played, followed by either the dialing sequence
or NOTHING STORED. NEW NUMBER is
then displayed.
Enter the dialing sequence you want to assign to
the R- key. If you make an error while entering
the dialing sequence, press the CLEAR key to
cancel your changes. Then enter the sequence
again.