Synchronising The Tcp/Ip Settings With The Gigaset Router - Gigaset SE105 Owner's Manual

Configuring the local network

Synchronising the TCP/IP settings with the Gigaset Router

You have now configured your computer so that it is ready to be connected to the
Gigaset Router. You now have to release the old TCP/IP settings and update them with
the settings of your Gigaset Router.
Click on Start in Windows Desktop and then Programs, followed by Accessoires
N
and finally command prompt.
In the command prompt window enter the
N
ipconfig /release command and press the ENTER KEY.
Then enter the
N
IPCONFIG /RENEW command and press the ENTER KEY.
If the router's default IP address (192.168.2.1) was not changed, the IP address
should now read 192.168.2.x (with x being a number between 2 and 254. The
Subnet mask must always be 255.255.255.0 and the Default Gateway must have
the router's IP address (192.168. 2.1). These values confirm that your Gigaset Router
is working.
Enter EXIT and press the Enter Key to close the command prompt window.
N
34