Gigaset SE105 Owner's Manual page 57

General configuration with Basic Setup
Configuring Connection via Cable modem
Complete this page if you connect to the Internet via a cable modem.
You may have been given a host name by your Internet Service Provider. If so, enter
N
it in the box Host name.
The MAC address
N
change this unless required to do so by your Internet Service Provider.
i
Click on FINISH to complete the setup.
N
Your WAN connection has now been configured.
Once you have completed configuration, the router will try to open an Internet
connection. If your configuration has been successful, a connection to your Internet
Service Provider's home page will be opened.
In this connection type your router is assigned a
the Internet Service Provider.
N
i
N
56
is set by default to the router's physical WAN interface. Do not
If your Internet Service Provider has used the MAC address of one of
your PCs for registration when setting up your broadband account,
connect only the PC with the registered MAC address to the router
and click on Clone MAC address. Then the router's current MAC
address will be replaced by the already registered MAC address of the
PC. If you are not sure which PC was used as the identifier, have your
Internet Service Provider register a new MAC address for your
account. Then use this MAC address for the router.
If you want to use a particular
this in Advanced Setup. To do this, select DNS in the WAN menu (see
page 66).
If you want to use a PC in your network as a server, you can use the
router's DynDNS service (see page 83).
Dynamic IP address
DNS Server, you will have to configure
by