Synchronising The Tcp/Ip Settings With The Gigaset Se505 Dsl/Cable - Gigaset SE505 Manual

Synchronising the TCP/IP settings with the Gigaset SE505 dsl/cable

You have now configured your PC so that it is ready to be connected to the Gigaset
SE505 dsl/cable. You now have to release the old TCP/IP settings and match them to the
settings of your Gigaset SE505 dsl/cable.
u
Click on Start – Run.
u
Type WINIPCFG and click on OK.
There may be a slight delay before the IP Configuration appears.
u
Select your network adapter from the selection list.
u
Click on Release and then Update.
If the router's default IP address (192.168.2.1) was not changed, the IP address
should now read 192.168.1.x (x being a number between 2 and 254). The Subnet
Mask must always be 255.255.255.0 and the Default Gateway must have the
router's IP address (192.168.2.1). These values confirm that your Gigaset SE505 dsl/
cable is working.
u
Click on OK to close the IP Configuration window.
Configuring the local network
27