Gigaset SE105 Owner's Manual page 94

Symptom
You cannot connect to the
Internet.
You cannot open a
connection from a wireless
device to the Gigaset Router.
Possible cause and solutions
Check that you are using the right cable to connect
N
to the modem. Depending on the modem you are
using, the cable must have either straight or cross
wiring. Please consult your modem operating
instructions. The Ethernet cable supplied has
straight wiring.
Check whether the Auto-reconnect option has
N
been deactivated (for PPPoE or PPTP connections).
In this case, connections cannot be opened
automatically.
Select Auto-reconnect. Remember that this setting
may lead to higher costs if you are billed on the time
used.
If the Auto-reconnect option has been activated,
N
perhaps the connection was terminated manually
on the Status tab using the Disconnect button.
– Open the connection manually using the Connect
button again or
– restart your router.
In both cases, the Auto-reconnect setting will be
active again.
The wireless network adapter is not using the correct
SSID.
Change the SSID on the network adapter.
N
WEP encryption has been activated on the Gigaset
Router but not on the wireless network adapter or it is
using the wrong WEP key.
Activate WEP encryption on the network adapter
N
with the correct key.
If you do not know the key, you will have to reset
your router. To do this, hold down the reset button
on the back of the router for at least five seconds.
Warning: Please bear in mind that this will restore all
configuration settings to the factory settings.
Appendix
93