Inserting And Labeling Electronic Modules 2 Do Relay Uc60V/2A - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Wiring
5.5 Inserting and labeling the power supply, interface module, and electronic modules
Changing the Type of Electronic Module
You have already removed the electronic module:
1. Use the screwdriver to press the coding element out of the terminal module.
2. Insert this coding element on the used electronic module.
3. Install the new electronic module (different type) on the terminal module, checking for an
audible latching sound.
4. Label the new electronic module.
Figure 5-15
See also
Modular system (Page 45)
5.5.4

Inserting and labeling electronic modules 2 DO Relay UC60V/2A

Inserting and labeling electronic modules 2 DO Relay UC60V/2A
1. Remove the Ex d isolating plug up to the end stop.
2. Use a screwdriver to loosen the locking lever from the latch and swivel the lever down.
128
DANGER
Making changes to the coding can lead to dangerous states in your system. In such cases
you have to check the installation and adjust it where necessary. In doing so also note the
safety data of the electronic module.
Replacing an electronic module with a different type
Operating Instructions, 11/2017, A5E00247483-07
ET 200iSP