Wiring Terminal Modules Tm-Em/Em - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Connecting sensors and actuators (right-hand module)
Refer to the Chapter "Wiring terminal module TM-EM/EM (Page 117)".
Wiring terminal module TM-IM/IM
Connect the two bus connectors for the redundant IMs. The procedure for TM-IM/EM is
described under
for the right-hand module.
①
②
③
Figure 5-7
For pin configuration, refer to the Chapter "Terminal module TM-IM/IM (Page 210)".
5.4.7

Wiring Terminal Modules TM-EM/EM

Properties
Terminal module TM-EM/EM forms the interface to the sensors and actuators.
Requirements
Observe the wiring rules.
ET 200iSP
Operating Instructions, 11/2017, A5E00247483-07
Connecting PROFIBUS RS 485-IS (left-hand module) . Repeat the same steps
Terminal module TM-IM/IM
Connection for IM 152 (b):
PROFIBUS RS 485-IS
Connection for IM 152 (a):
PROFIBUS RS 485-IS
Wiring terminal module TM-IM/IM (PROFIBUS RS 485-IS)
Wiring
5.4 Wiring the ET 200iSP
117