Inserting And Labeling The Im 151-2 And Electronics Modules - Siemens SIMATIC ET 200iS Manual

Wiring
3. Pull the power supply module PS out of the terminal module TM-PS keeping a
firm hold on it (weight, approx. 2.5 kg).
4. Now push the release slider fully up while pressing in the button.
Inserting and Labeling the Interface Module and Electronics Modules
1. Insert the interface or electronics module into the terminal module until you hear
it lock in place.
2. To allow identification, take the labeling strip out of the interface or electronics
module towards the top.
3. Finally, reinsert the labeling strip in the interface or electronics module again.
Figure 6-11 Inserting and Labeling the IM 151-2 and Electronics Modules
Note
To operate the ET 200iS, and electronics module must be inserted on every
terminal module TM-E.
6-28
2
3
1
ET 200iS Distributed I/O Station
A5E00087831-02