Wiring Terminal Modules Tm-Im/Em And Tm-Im/Im - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Wiring
5.4 Wiring the ET 200iSP
3. Secure the individual wires using the 3.5 mm screwdriver.
Note
The grounding cable (equipotential bonding) must have a cross-section of at least 4 mm
Connect the other end of the grounding cable Pa with the ground bus PA.
4. Lift the slide until this move upwards of its own accord.
Figure 5-5
Note
When wiring the TM-PS-A UC / TM-PS-B UC, make sure to connect the phase L1 and the
neutral conductor N properly. This is necessary to ensure a trouble-free operation of the
ET 200iSP.
5.4.6

Wiring Terminal Modules TM-IM/EM and TM-IM/IM

Properties
Connect the PROFIBUS RS 485-IS connector to terminal module TM-IM/EM. The connector
is on the left-hand side of the module. Terminal module TM-IM/EM also forms the interface to
the actuators and sensors. The connectors are on the right-hand side of the module.
Connect the bus connector to terminal module TM-IM/IM for redundant operation of the two
IM 152s.
114
①
Terminal module TM-PS-A/ TM-PS-A UC
②
Catch
Connecting the Power Supply and Grounding Conductor PA to the TM-PS-A/ TM-PS-
A UC.
Operating Instructions, 11/2017, A5E00247483-07
.
2
ET 200iSP