Redundancy Of The Power Supply - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Configuration options

3.11 Redundancy of the Power Supply

I&M
DEVICE_INSTALL_ DATE
M data 3: Index 4 (data record 234)
DESCRIPTOR
The display of this I&M depends on the engineering software.
1
See also
Project Engineering with GSD File and SIMATIC PDM (Page 137)
3.11 Redundancy of the Power Supply
Properties
With the ET 200iSP, you can configure a redundant power supply PS. When one power supply
PS fails, the system fails over to the second power supply PS without interruption.
Requirements
● Terminal module TM-PS-A/ TM-PS-A UC
● Terminal module TM-PS-B/ TM-PS-B UC
● 2 x Power Supply PS
● IM 152 (V2.0 and higher)
Combination options of the power supply PS with TM-PS-A and TM‑PS‑B
TM-PS-A
PS 24 VDC*
* All product versions
Combination options of the power supply PS with TM-PS-A UC and TM‑PS‑B UC
TM-PS-A UC
PS 24 VDC*
PS 120/230 VAC**
PS 24 VDC*
* Product version 7 and higher
** Maximum output current, refer to technical specifications in the section
60
Access Default
read / write (16 ---
bytes)
read / write (54 ---
bytes)
Explanation
Enter the installation date of the module
here.
Enter a comment on the module here.
TM-PS-B
PS 24 VDC*
TM-PS-B UC
PS 24 VDC*
PS 120/230 VAC**
PS 120/230 VAC**
Power Supply PS 120/230 VAC
Operating Instructions, 11/2017, A5E00247483-07
ET 200iSP