Change The Network Settings; Settings For The Wired Port; Settings For The Wi-Fi Port - Fluke CableAnalyzer DSX-602 User Manual

DSX-602 CableAnalyzer
Users Manual

Change the Network Settings

It is not usually necessary to change the wired or Wi-Fi network
settings before you try to make a connection. But for example if
you must use static addressing, you can get to the settings on the
NETWORK screen.
To get to the network settings
On the home screen, tap TOOLS, then tap Network, then tap the
Wired or Wi-Fi panel.
To test the settings
Tap CONNECT on the WI-FI PORT or WIRED PORT screen.

Settings for the Wired Port

The tester can use DHCP (dynamic host configuration protocol) or
Static for the address method. Most networks use DHCP.
For Static, enter an IP address for the tester and the Subnet Mask,
Gateway address, and DNS1 and DNS2 addresses for the network.
If you are not sure what to enter, speak to the network
administrator.

Settings for the Wi-Fi Port

Table 5 shows the Wi-Fi settings.
88