Password Entry; Change The Password - Fluke v3000 FC Calibration Manual

v3000 FC
Calibration Manual

Password Entry

To go to the calibration mode, push  five times until CAL is shown. You will
need to enter a password to access calibration mode.
To enter the password:
1. Push  and the CAL counter is shown. For example n002.
2. Push  to show "????".
3. Push  to change the first digit of your password (default: 1234).
4. Push  to confirm your choice. The subsequent "?" changes to "_".
5. Do steps 3 and 4 again to enter the subsequent digits of the four-number
6. When all of the correct digits are entered, push  to confirm the input.

Change the Password

If you change the password and then lose it, see the "Restore the
Default Password" section.
To change the password:
1. Do steps 1 through 5 in the "Password Entry" section.
2. Before you push  to confirm your final input (step 6), push  to show "----"
3. Push  to change the first "-" to the first digit of your new password.
4. Push  to confirm your choice.
5. Repeat steps 3 and 4 to enter the subsequent digits of the new four-number
6. When the correct digits are entered, push  to confirm the input and change
8
password.
If the correct password is entered, "C-01" is shown. If the incorrect password
is entered, "????" is shown and the password must be correctly entered.
on the display.
password.
the password. If the Product has been calibrated, it will go to normal
measurement mode.
Note