How To Remove The Memory Pack - Omron SYSMAC C500 Installation Manual

Assembly
How to Remove the
Memory Pack
26
2. Using a standard screwdriver, remove the Memory Pack compartment
cover located on the front panel of the CPU. Push in the latch on the
cover and slide the cover upward.
SYSMAC C500
PROGRAMMABLE CONTROLLER
OMRON
POWER
RUN
ERR
ALARM
OUT INMB
Use a standard screwdriver to remove the Memory
Pack compartment cover.
3. Insert the Memory Pack (component side facing left) into the Memory
compartment. When the Unit is almost completely inserted into the CPU,
there may be a slight resistance as the Memory Pack connector mates
with the connector inside the CPU. Continue pushing on the Memory
Pack until it is inserted completely into the CPU.
4. Reattach the memory compartment cover.
Follow the steps below to remove the Memory Pack from the CPU.
1. Turn the power to the PC OFF.
2. Using a standard screwdriver, remove the Memory Pack compartment
cover located on the front panel of the CPU. Push in the latch on the
cover and slide the cover upward.
3. Pull the Memory Pack up and out.
Memory Unit guide
Memory Pack
(ROM or RAM Pack)
Section 3