Robertshaw Smart Sense Series Installation Manual page 10

The switches must be set correctly for each system configuration. Follow these
steps:
1. Review the settings in Table 1.
2. Read the switch descriptions.
3. Mark or write down the switch positions that you will use.
4. In the figures that follow, find the wiring diagram that accurately describes
your equipment.
5. Review the switch settings next to the wiring diagram. If there are any
differences between that list and your selections, review your list. Be certain
you have the correct wiring diagram and choices for switch positions.
The ModBus and TT terminals will be described later in this manual.
10