Table of Contents
Advertisement
Mounting the SMART 2000 Thermostat
IMPORTANT:
The SMART 2000 can only be as accurate as the onboard
temperature sensor, or its optional remote temperature sensor(s)
permit. The thermostat should be mounted in a location that is
typical of the ambient room temperature. Do not install it near the
floor, in a draft, behind a door, or on a non-insulated, exterior wall.
Install the thermostat away from exposure to sunlight and four to
five feet (12.2 to 1.5 m) above the floor.
• Lift the cover (Figure 1) on the housing to expose a slot at the bottom. Take notice
of the decorative cover hinge points and the connection between the two halves.
• Insert a screwdriver or coin into the slot and twist. This will separate the two
halves.
Figure 1
7
Hide quick links:
Advertisement
Table of Contents
