Storing Fax Operations (Program) - Sharp MX-M1100 User Manual

STORING FAX OPERATIONS (Program)

A destination, original settings, and functions can be stored in a program. When you wish to use those settings to send
an image, they can be retrieved with ease.
For example, suppose 8-1/2" x 11" (A4) size documents are scanned into a file and sent to each branch office once a
month.
(1) The same documents are sent to each branch office
(2) Each page of a bound document is successively transmitted
(3) Smudges on the edges of the documents are erased before transmission
When a job program is not stored
Enter the address of each branch office.
Select Dual Page Scan.
Select Erase settings.
Press the [START] key (
The originals are scanned and transmitted.
Considerable time is required to send the documents each
month because the above settings must be selected.
In addition, mistakes may occasionally be made when
selecting the settings, so incorrect transmissions may occur.
• Programs are stored, edited, and deleted using "Address Control" in the system settings. See
(page 174).
• Programs can also be stored in the Web pages. Click [Job Programs] and then [Image Send] in the Web page menu.
• The settings stored in a program will be retained even after the program is used for transmission. The same settings can
be used repeatedly for transmission.
• The following settings can be stored in programs.
Scan mode, Internet fax mode
- Destinations
- Image settings: Resolution, Exposure
- Special modes: Erase, Dual Page Scan, Suppress Background, 2in1
Fax mode
- Destinations
- Image setting: Resolution, Exposure
- Special modes: Polling Reception, Erase, Dual Page Scan, 2in1
- F-code communication: A destination that includes an F-code can be stored to perform an F-code operation.
• Up to 48 programs can be stored.
• Up to 500 destinations can be stored in one program. (If a Scan to Network Folder destination is selected, only one
destination can be stored.)
• This function cannot be used in USB memory mode or data entry mode.
).
When a program is used, settings are selected with ease by
simply pressing the stored key.
In addition, transmission takes place based on the stored
settings so there are no chances for mistakes.
90
When a job program is stored
Touch a stored program key.
Press the [START] key (
The originals are scanned and transmitted.
).
"ADDRESS CONTROL"