Printing Is Not Possible Or Stops During A Job - Sharp MX-M1100 User Manual

Problem
The operation panel
cannot be used.
Printing is not
possible or stops
during a job.
Point to check
Does a message appear indicating that
Auto Login failed?
Does the message "Call for service.
Code:xx-xx*." appear in the touch
panel?
*Letters and numbers appear in xx-xx.
Is a tray out of paper?
Is the machine out of toner?
Has a paper misfeed occurred?
Is the output tray full?
Is the toner collection container full?
In the Paper Tray Settings of the system
settings, are restrictions placed on the
trays that can be used in each mode
(copy, print, fax, Internet fax, and
document filing)?
Auto Login failed due to a problem on the network.
Contact your administrator.
If you are the administrator, touch the [Admin Password]
key, log in as an administrator, and temporarily change
the auto login settings in the system settings
(administrator). (Restore the changed settings to their
original state after the network problem has been
solved.)
Make sure that data is being sent or received and then
switch off the [POWER] key (
switch. Wait at least 10 seconds and then switch the
main power switch and the [POWER] key (
on in that order.
☞
TURNING THE POWER ON AND OFF
If the message still appears after switching the
[POWER] key (
several times, it is likely that a failure has occurred that
requires service. In this event, stop using the machine,
unplug the power plug, and contact your dealer or
nearest SHARP Service Department. (When contacting
your dealer or nearest SHARP Service Department,
inform them of the displayed error code.)
Add paper as instructed by the message in the touch panel.
When toner runs low, a message will appear to inform
you that the toner cartridge must be replaced. To
replace the toner cartridge, see "REPLACING THE
TONER CARTRIDGE" in the Maintenance Guide.
Remove the misfeed as instructed by the message in
the touch panel.
☞
"3. REMOVING MISFEEDS" in the Maintenance
Guide
When the output tray becomes full, a detector activates
and stops printing.
Remove the output from the tray and resume printing.
Replace the toner collection container as instructed by
the message in the touch panel.
☞
"REPLACING THE TONER COLLECTION
CONTAINER" in the Maintenance Guide
Check the Paper Tray Settings and see if checkmarks
appear in the checkboxes of each mode (Feeding
Approved Job). Functions without a checkmark cannot
be used for printing using that tray.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings" > "Change" >
85
Solution
) and the main power
(page 18)
) and main power switch off and on
(Each mode)
) back