General Procedure For Using Stamp; Select The Print Position - Sharp MX-M1100 User Manual

GENERAL PROCEDURE FOR USING STAMP

To select stamp settings, follow the steps below.
Place the original.
1
Place the original face up in the document feeder tray, or face down on the document glass.
Select the special modes.
(1) Touch the [Special Modes] key.
2
(2) Touch the
(3) Touch the [Stamp] key.
☞
SPECIAL MODES
Special Modes
Stamp
Date
Page
Numbering
3
• "Date" and "Page Numbering" cannot be selected in multiple positions. If the [Date] key or [Page Numbering] key is
touched when "Date" or "Page Numbering" has already been selected for a position, a message will appear asking
you if you wish to move that item to the selected position. To move the item, touch the [Yes] key. Otherwise, press
the [No] key.
• If you attempt to set "Date", "Text", or "Page Numbering" in a position where one of these items is already set, a
message will appear. To change the previously selected item to the new item, touch the [Yes] key. To keep the
previous item, touch the [No] key.
keys to switch through the screens.
(page 43)
Cancel
Stamp
Text
Layout

Select the print position.

OK
Select from 6 positions: top left, top center, top right, bottom
OK
left, bottom center, bottom right.
1
You can also skip this step and go directly to the next step. In
2
this case, the stamp items will be printed in the following
positions:
Date: Top right
Page number: Bottom center
Print positions
The keys that show the print positions will appear as follows
depending on the state of the settings.
The above key is the top left key. The appearance of each key
varies depending on the position of the key.
84
Stamp: Top left
Text: Top left
Not selected, stamp setting has not
been selected.
Selected during selection of the stamp
setting.
Not available, stamp setting has already
been selected.