Document Glass - Sharp MX-B350W User Manual

BEFORE USING THE MACHINE►HOW TO PLACE THE ORIGINAL

DOCUMENT GLASS

This section describes the steps for setting the original on the document glass.
• Close the automatic document feeder slowly. Abruptly closing the automatic document feeder may damage it.
• Take care that your fingers are not pinched when closing the automatic document feeder.
Allowed original sizes
Maximum original size
Standard size
8-1/2" (longitudinal) x 14" (transversal)
210 mm (longitudinal) x 297 mm (transversal) or A4
Non-standard size
8-1/2" (longitudinal) x 14" (transversal)
216 mm (longitudinal) x 356 mm (transversal)
When the original is a non-standard size, see the appropriate explanation below for the mode you are using.
COPIER: "SPECIFYING THE SIZE OF THE ORIGINAL (page
►
FAX: "BASIC PROCEDURE FOR SENDING FAXES (page
►
SCANNER: "BASIC TRANSMISSION PROCEDURE (page
►
Open the automatic document feeder.
1
2
Document glass
scale
Close the automatic document feeder.
3
After placing the original, close the automatic document feeder. If the unit is left open, parts outside of the original will be
copied in black, causing excessive use of toner.
If originals have damp spots due to correction fluid, ink or paste up glue, wait until the originals are dry before making
copies. Otherwise the interior of the machine or the document glass may be soiled.
Mark
Y
X
2-11)"
4-8)"
5-5)"
Load the paper with the print side
facing down.
Place the original face down and align the top left corner of
the original with back left (at the tip of the mark
document glass.
1-32
) of the