Fax - Sharp MX-B350W User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS

Fax

System settings for the fax function are explained below.
List Setting
This setting is used to print lists showing current system
settings and other programmed information.
Select the [List Setting] to configure the settings.
Print Selection
This setting is used to select the conditions for printing
out transaction reports for normal transmission,
broadcast transmission, original print and reception.
Transmission Broadcast
Always Prints Always Prints
Error Only Error Only
Never Prints Never Prints
Reception
Always Prints
Error Only
Never Prints
Normally the settings indicated by shading
above are selected.
"Transmission", "Broadcast", "Original Image Print
Setting", or "Reception" can be selected.
• If you selected "Transmission", select "Always Prints",
"Error Only", or "Never Prints".
• If you selected "Broadcast", select "Always Prints",
"Error Only", or "Never Prints".
• If you selected "Original Image Print Setting", select
"Always Prints", "Error Only", or "Never Prints".
• If you selected "Reception", select "Always Prints",
"Error Only", or "Never Prints".
"Original Image Print Setting" is used to have part of
the first page of the transmitted document printed on
the transaction report. This setting is not effective
when the transaction report is set to not print out.
Auto Listing
This setting is used to have the activity report that is
stored in the machine's memory printed out at regular
intervals.
You can choose to have the report automatically printed
each time the number of stored transactions exceeds 50,
or have the report printed at a specified time every day
(only once per day). You can also enable both print
methods.
The report is normally set to not print out. To have the
report automatically printed when the number of stored
transactions (the combined total of transmissions and
receptions) exceeds 50, select "Auto Print Rept At
Limit(50)".
Original Image
To have the report printed at a specified time, enable
Print Setting
"Print Time Set" and enter the desired time.
Always Prints
• The setting is enabled and a checkmark appears in
Error Only
• If this procedure is performed when the setting is
Never Prints
7-18
the checkbox.
enabled, the checkmark will be cleared and the setting
disabled.
• To cancel a "Print Time Set" setting, select
"Cancel":
• Select "Cancel" with the [ ] or [ ] key and then
press the [OK] key.
• If "Auto Print Rept At Limit(50)" is not enabled and
the number of recorded transactions exceeds 50,
each new transaction will delete the oldest
transaction.
• The activity report can also be printed out on
demand. (See PRINTING LISTS OF
PROGRAMMED INFORMATION AND SETTINGS
(page 4-45).)