Table of Contents
Advertisement
SYSTEM SETTINGS►SYSTEM SETTINGS
SYSTEM SETTINGS
Change Admin PIN
Use this function to change administrator PIN code. To
change the administrator PIN code, see
"PROGRAMMING AN ADMINISTRATOR PIN CODE
(page
7-2)".
Initial Setting
The default settings for operation of the machine can be
configured. Select the [Initial Setting] to configure the
settings.
Date & Time Set
Use this to set the date and time in the machine's built-in
clock.
Daylight Saving Time
Enable daylight saving time.
Network
Network settings are described below.
Select the [Network] to configure the settings.
Confirmation of Network
Confirm network settings.
Connection Type
You can change the machine's network connection type.
Wired settings
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network,
use this setting to configure the IP address of the
machine. The settings are shown below.
Enable DHCP
Use this setting to have the IP address obtained
automatically using DHCP (Dynamic Host Configuration
Protocol). When this setting is enabled, it is not
necessary to manually enter an IP address.
IPv4 Address
Enter the IP address of the machine.
Subnetmask
Entry the Subnetmask
Default Gateway
Enter the Default Gateway.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network,
use this setting to configure the IP address of the
machine.
The settings are shown below.
Enable IPv6 Protocol
Enable this setting.
Enable DHCPv6
Use this setting to have the IP address obtained
automatically using DHCP (Dynamic Host Configuration
Protocol). When this setting is enabled, it is not
necessary to manually enter an IP address.
Manual Address
Enter the IP address of the machine.
Prefix Length
Enter the prefix length (0 to 128).
Default Gateway
Enter the IP Gateway address.
• If DHCP is used, the IP address assigned to the
machine may change automatically. If the IP
address changes, printing will not be possible.
• In an IPv6 environment, the machine can use LPD
protocol.
7-10
Advertisement
Chapters
Table of Contents
