Bowflex BXT116 Service Manual page 48

12. Using a #2 Phillips screwdriver, remove the 10 indicated screws from the
Bottom Motor Cover.
Note: The Base Frame Weldment has been removed for clarity.
13. Remove the old Bottom Motor Cover and attach the new Bottom Motor
Cover.
Note: Be sure to route the cables from the Base Assembly through the new
Bottom Motor Cover.
14. Using two 17mm wrenches in the Motor Compartment, reattach the hard-
ware to the Incline Motor Assembly.
15. Make sure there is sufficient space to tilt the machine back upright and that
the area is clear.
This step requires two people. Be sure there is adequate clear-
ance for the raised deck. Some components of the equipment can
be heavy or awkward. Enlist the service of a second person when
you do maintenance steps involving these components. Do not try
to do heavy or awkward steps on your own.
16. Re-install and connect all remaining parts that were removed in reverse
order.
17. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
Base Frame Weldment removed for clarity.
48