6. Gently release the front snaps (indicated by ovals) that secure the
Motor Cover and pivot it back toward the walking belt until it releases.
Remove from the machine.
7. Using a #2 Phillips screwdriver, remove the 2 indicated screws from
the Motor Control Board Cover. Lift and remove the Motor Control Board
Cover.
Motor Control Board Cover
8. Release the Securing Clips from the Power Inlet and remove it from the
Frame.
9. Remove the connectors and attach them to the new Power Inlet. Be
sure to attach them in the same locations on the new Power Inlet.
Power Inlet
10. Insert the new Power Inlet into the Frame being sure the Securing
Clips engage.
133