Walking Belt stops while in use, moves briefly, or does not move at all (Console lights up)
If the Console powers up and the Start
BEGIN HERE:
button beeps or causes the Display to
change, then the Console is NOT defective.
Turn machine power off
for at least 5 seconds
before turning back on.
Begin a quickstart/manual
workout.
Replace Speed Sensor
NO
Does the Belt move
at all?
YES
Shut off machine and wait
5 minutes. Remove Motor
and MCB Cover. Verify
Speed Sensor is properly
aligned and check Sensor
and wire for damage.
YES
Does sensor/wire
need replacement?
NO
YES
Is the issue still
present?
NO
Issue resolved
Perform Service Mode
Procedure 2 to test
Console communications
YES
Did the
belt move for a few
seconds and then
stop?
NO
Perform Service Mode
Procedure 2 to test
Console communications
27
Replace I/O Cables
NO
Did communication
test pass?
YES
Disconnect machine
power for 1 minute. Follow
Service Mode Procedure
3 to reset Console, then
Service Mode Procedure
4 to calibrate the MCB.
Is the issue still
YES
present?
NO
Issue resolved
Contact
Tech Support at
800.861.7401
for further assistance.