Bowflex BXT116 Service Manual page 36

5. Using a #2 Phillips screwdriver, remove the two indicated screws from
the Rear Roller Cover.
6. Remove the Rear Roller Cover noting how it attaches for re-assembly.
7. Using a 10mm wrench, loosen the indicated hardware and adjust the
cable.
8. Tighten the hardware when adjusted.
9. Make sure there is sufficient space to lower the walking deck.
Keep a minimum clearance behind the machine of 79" (2 m)
and 24" (0.6 m) on each side. This is the recommended safe
distance for access, movement and emergency dismounts
from the machine.
10. Make sure there is no object on or around the treadmill to spill or
cause blockage from the fully unfolded position.
11. Slightly push the walking deck forward toward the console, and then
push the Deck Release Handle until the locking tube releases and you
can pull the walking deck away from the console. Hold up the rear of the
walking deck, and move to the side of the machine.
Keep clear of the movement path of the walking deck.
Rear Roller Cover
36