Bowflex BXT116 Service Manual page 105

7. Using a 6mm hex wrench, remove the 8 screws that secure the Con-
sole Assembly from the Right and Left Uprights.
Note: To assist with re-assembly, be sure to note that the curved washers
are used facing the rear of the machine.
8. Fully remove the Console and Handlebar Assembly from the Uprights.
do not raise the deck
9. Remove the Lower Junction Covers from the Uprights.
Lower Junction Cover
Crossbar Tray
10. Remove the Crossbar Tray from the Crossbar.
11. Remove the Right Base Shroud from the Base Assembly.
Right Base Shroud
12. Using a 6mm hex wrench, remove the 4 screws from the Crossbar.
Be prepared to support the Crossbar when the hardware is removed.
Crossbar
105