Bowflex BXT116 Service Manual page 129

11. Attach the new Motor Mount to the Motor. Be sure the Belt Tensioner
Screw is properly oriented toward the rear of the machine when the Motor is
re-installed.
12. Lightly attach the Motor Assembly to the Frame. Be sure to only finger
tighten the hardware.
13. Loop the Drive Belt onto the Motor Pulley. With the Drive Belt looped onto
the Motor, carefully roll the Drive Belt onto the Drive Pulley in a clockwise mo-
tion. Be sure the Belt does not come off of the Motor Pulley.
Keep fingers out of any pinch opportunities when turning the
Pulleys.
14. Roll the Drive Pulley clockwise until the Drive Belt is fully installed. Con-
tinue to roll the Belt forward while adding side pressure with fingers to align as
necessary.
15. With the Motor Assembly loosely attached to the Frame, turn the Belt
Tensioner Screw to the previous level. This will tighten the Drive Belt to the
previous tension level.
16. Using a 6mm hex wrench, fully tighten the screws that attach the Motor
Assembly to the Frame.
17. Re-install all remaining parts that were removed in reverse order.
18. Attach the power cord and turn on the Treadmill by flipping the power
switch to ON.
19. From the Power Up (or Welcome) screen, push and hold down the
PAUSE/STOP button and Down arrow button for about 5 seconds to go into
the Machine Setting Mode. The Console display will show the TOTAL HOURS
screen.
Belt Tensioner Screw
Motor Mount
129
Drive Belt
Motor