Engineering Mode - Bowflex BXT116 Service Manual

ENGINEERING MODE

ENGINEERING MODE is a sub-menu from the MACHINE SETTINGS MODE. Most of the options contained within the
Engineering Mode are for Service Technicians and should not need to be accessed by a user.
To access the Engineering Mode:
1. From the Power Up (or Welcome) screen, push and hold down the PAUSE/STOP button and Down arrow button for
about 5 seconds to go into the Console Setup Mode. The Console display will show the TOTAL HOURS with the current
value.
Note: Push PAUSE/STOP to exit the Console Setup Mode and return to the Power-Up Mode screen.
2. From the TOTAL HOURS screen, push and hold down the PAUSE/STOP button and Down arrow button for about 5
seconds to go into the Engineering Mode. The Console display will show the current Firmware Version.
Prompts displayed by the Console (in order using the Down arrow button) :
A. ENTR MFG TEST
B. Firmware Version ( "xxxxxxxxxxRxx" )
C. ENTR NVM (Non-volatile memory) TST
D. ENTR LCD
E. ENTR LED TST 1
F. ENTR LED TST 2
G. ENTR RTC (Real time clock) TST
H. ENTR AUD (Audio) TST
I. ENTR HR TST
J. ENTR KEY TST
K. ENTR FAN TST
L. ENTR BLE (Bluetooth Low Energy) TST
M. ENTR ESTOP (Emergency Stop) TST
N. ENTR MCB TST
O. ENTR MCB CLB (Calibration)
P. ENTR RST CNSL (Reset Console)
Push the PAUSE/STOP button twice to exit Engineering Mode.
30