Adjusting Width Of Armrests; Adjustment Options For Parallel Sliding Armrests; Setting The Height Of The Parallel Sliding Armrests - Invacare Storm 4 Series User Manual

5.3.3 Adjusting width of armrests

WARNING!
Serious risk of injury if one of the armrests
falls out of its bracket because they have
been adjusted to a width which exceeds the
permissible value
– The width adjustment is fitted with red
markings A and the word "STOP". The
armrests must never be pulled out further
than the point at which the word "STOP" is
completely legible.
– Always tighten the fixing screws properly once
adjustments have been completed.
Depending on the side, the screw is accessible from
the front or the rear.
• 8 mm Allen key
1529686-U
1. Loosen screw (1).
2. Adjust armrest to required position.
3. Re-tighten screw.
4. Repeat this procedure for the second armrest.
5.4 Adjustment options for parallel sliding
armrests

5.4.1 Setting the height of the parallel sliding armrests

The height of the parallel sliding armrest is set using the
armrest angle.
Setup
35