Opening Rear Shroud; Disconnect The Power Module - Invacare Storm 4 Series User Manual

Invacare® Storm®⁴ Series
• Batteries should always be fully charged before storing.
• If storing the mobility device longer than four weeks,
check the batteries once a month and recharge as
needed (before gauge reads half full) to avoid damage.
• Store in a dry, well-ventilated environment protected
from outer influences.
• Slightly overinflate pneumatic tires.
• Position the mobility device on flooring that is not
discolored by contact with tire rubber.
Preparing mobility device for use
• Re-connect the battery supply to the power module.
• The batteries must be charged before use.
• Have the mobility device checked by an authorized
Invacare provider.

9.7 Opening Rear Shroud

Removing Rear Shroud
1. Loosen and remove two hand screws (1) on left and
right side of rear casing.
2. Lift rear shroud carefully. Front part of shroud is held at
top by hook and loop strip. This must also be released.
112
Fitting Rear Shroud
1. Fit parts in reverse order.
2. Tighten hand screws by hand.

9.8 Disconnect the power module

1.
Remove the rear cover, refer to 9.7 Opening Rear
Shroud, page 112 .
2.
Remove the battery cable (1) from the power module.
1529686-U