Adjusting The Mobility Of The Parallel Sliding; Armrests - Invacare Storm 4 Series User Manual

1.
Undo the bolts on both sides of the backrest cover (1).
The photograph only shows the bolts on the left-hand
side.
2. Remove the backrest cover (2).
3.
On the torque support, loosen the locating pin (3) bolt
(2) with the Allen key.
4. Reduce the load on the armrest by raising it slightly and
then remove the locating pin.
1529686-U
5.
Adjust the armrest width.
The possible positions for the armrest are predefined by
the drill-holes in the torque support and the armrest
axel.
6. Insert the locating pin.
7. Retighten the screw.
8. Repeat the procedure for the other armrest.
9.
Replace the backrest cover (2). When doing so, ensure
that the recesses in the sides are located correctly.
10. Retighten the bolts on both sides of the backrest cover
(1) again.
The photograph only shows the bolts on the left-hand
side.

5.4.4 Adjusting the mobility of the parallel sliding

armrests

The flexibility of the parallel sliding armrest can be adjusted
to easier or stiffer.
Setup
37