Table of Contents
Advertisement
dust collection
this machine creates a lot of wood chips/
dust during operation. breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
minimum cfm at dust port: 400 cfm
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Model G0634Z/G0634XP (Mfd. Since 01/11)
to connect a dust collection hose:
1.
Fit the 4" dust hose over the jointer dust port,
(see figure 24), or over the planer dust port
(see figure 25), depending upon operation
mode, and secure in place with a hose clamp.
figure 24. example of dust hose attached to
jointer dust port.
figure 25. example of dust hose attached to
planer dust port.
2.
tug the hose to make sure it does not come
off.
note: A tight fit is necessary for proper
performance.
-25-
Advertisement
Table of Contents
